12/26/2023 0 Comments Diy giant jenga game and storage![]() ![]() I sanded the insides of the holes with my oscillating spindle sander and rounded the edges of the holes over with a 1/4 inch rounder bit in my router. Once the holes are drilled I cut along the outside lines of the rectangle with my jig saw and connected the two holes to make one large handle hole in each of the boards. If you can get something larger, maybe 15x15x15, you should be good What are yard. The total size of this board is 36 tall by. Using a 2 inch forstner bit I drilled 2 holes in each board on the 2 center points I marked on the rectangle that were 1 inch in from the end. We used a milk crate to cart ours around in, but it wasnt quite big enough. This guide will walk you though building the game board, legs, storage tray and playing discs, all out of wood. These points will act as center marks for the holes that will be drilled I marked a center line horizontally across the rectangle and marked a point 1 inch in from each side. Don’t worry about where to put these blocks when you’re done. ![]() However, these blocks are over eight times the size of normal Jenga blocks, resulting in a tower nearly 22 inches wide and stacked to over 4 feet high. From the center I measured 3 inches in each direction, marked 2 lines, measured down 4 inches from the top and marked a line across the board, measured 2 inches down from the top and marked another line across.įor the handles I first laid out a rectangle that was centered on each of the side boards 6 inches wide, 2 inches tall, and 2 inches down from the top of the board. Jenga Giant JS6 is identical to the original game: it comes with 54 precision-crafted premium woodblocks. For the layout of the handles I first found the center point of both the left and right side boards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |